New Trailers
Convertible Tipper MK III
STANDARD SPECIFICATIONS
| DIMENSIONS: | Length up to 13700mm (45’) x 2500mm (8’ 2 ½”) wide. Front floor height is approx. 1655mm based on a 1250mm turntable height. |
| CHASSIS: | Fabricated ‘I’ Beam with 130mm x 12mm top and bottom flanges. |
| COAMING RAILS: | 100mm x 45mm High Tensile RSJ with 25 N.B. pipe tie rail. Option: 125mm x 65mm RSJ |
| CROSSMEMBERS: | 100mm x 45mm RSJ Option: Container beams to suit 1 x 40ft., 2 x 20ft., or 1 x 20ft |
| FLOOR: | 2.5mm Lyten sheet |
| AXLES: | York Model 2782 – 20” spider Option: Various Axle brands and models available |
| TYRES: | Nil. (Range available) |
| RIMS: | Nil. (Range of steel spider, 10 stud steel or aluminium rims available) |
| SUSPENSION: | York MT75 8’1” Spring Tri-axle cast steel overslung. Option: Various spring or air suspension brands available. |
| KING PIN: | 50mm Jost bolt-in (D-value 190kN) with bolt-on turntable block |
| BRAKES: | Air Brake Corp Tri-axle to ADR 38/02 Specifications. Option: Road train brake kit. |
| LANDING LEGS: | Jost A400 Series mounted on drawbar |
| TYRE CARRIER: | Dual through chassis type, hinged on rubber bushes |
| TOOLBOXES: | One x 1200mm lockable type with spring loaded catches Option: Additional toolboxes may be fitted. |
| WATER TANK: | One x 60 litre galvanised Option: Plastic water tank available |
| MUDGUARDS: | Pressed aluminium tread plate guards with mudflaps in front of suspension. Long mudflap hung off bumper bar at rear of suspension. |
| DRAWARMS: | Double ‘A’ Frame drawbar with pivoting skidplate |
| GATES: | 1525mm (5’) high twin bow High Tensile RHS. Removable front load rack Option: 1675mm (5’6”) or 1830mm (6’) high gates, tarp bow rack available |
| TAILGATE: | Three-way opening, half sheeted with centre grain door and chute |
| HOIST: | Hyva 50 tonne – 5 stage. Two purpose built 5 stage starter rams |
| LIGHTS: | Lights (wired in conduit), Reflectors, and Rear Marker Plates conforming to all relevant Australian Design Rules. Option: LED Lights – Side and Rear |
| PAINT: | Trailer is deburred and fully sandblasted prior to painting with Etch Primer undercoat and PPG 2K finish coat to Fleet or Customer colours (with scrollwork to suit) Option: Various finishes are available including Metallics, Clear-Over-Base, and Chemical resistant paints |
| OTHER OPTIONS: | Gate Rack, Winches (clip-on or track type), Winch Track, Single Draw Arms, Spray Suppressant Mudguards and Flaps, Hubodometer, Ringfeeder (bracket only or complete), LargeToolbox (with or without shelf), Spare Tyre Clamp, Vibrator, Hydraulic Power Pack |
THESE SPECIFICATIONS ARE A GUIDE ONLY, AS EACH RHINO TRAILER CAN BE DESIGNED AND MANUFACTURED TO SUIT THE CUSTOMER’S SPECIFIC REQUIREMENTS